Line Engineering
Filling Line Utility Load Guide
Utility planning consolidates electrical load, voltage and frequency, compressed air, water qualities, drainage, cooling, steam or heat and ventilation for every module. Peak and normal demand should both be stated.
Direct answer
What this decision means for a real filling project
Utility planning consolidates electrical load, voltage and frequency, compressed air, water qualities, drainage, cooling, steam or heat and ventilation for every module. Peak and normal demand should both be stated.
This guide is part of the Capacity and Line Engineering cluster. Read the hub when the project still needs a broader comparison.
Engineering inputs
Define the duty before comparing equipment
A useful proposal starts from agreed process and package information. These inputs keep suppliers from filling gaps with incompatible assumptions.
Send these details
- Site voltage and frequency
- Available transformer capacity
- Air pressure and flow
- Water and drainage
- Steam cooling or ventilation
Require these checks
- Issue a consolidated utility table
- Mark connection points
- Compare peak and normal loads
- Test utilities before commissioning
Line integration
Connect the choice to upstream and downstream equipment
A production line is limited by its constrained process, not the largest number printed on one machine. Upstream supply, filler cycle, closure handling, label and pack changes, accumulation and operator response should be balanced as one system.
Comparison sheet
Put every supplier on the same basis
| Decision area | What to state in the RFQ | What to verify |
|---|---|---|
| Product | site voltage and frequency | issue a consolidated utility table |
| Package | available transformer capacity | mark connection points |
| Performance | air pressure and flow | compare peak and normal loads |
| Operation | water and drainage | test utilities before commissioning |
| Project scope | Utilities, interfaces, documents, spares, packing, shipping and support | Written inclusions, exclusions and acceptance evidence |
Verification route
Move from a claim to recorded evidence
Agree on bottle size, product condition, sustained test duration, acceptable stops and quality losses. Record actual output at each section and identify whether short stops, starvation or blocking prevent the target from being sustained.
- Approve the duty, drawings and test conditions before fabrication is treated as final.
- Use production-intent product and packaging wherever they materially affect performance.
- Record results by format, operating condition and quality criterion rather than relying on a short edited video.
- List open items, owners and closure evidence before packing and again after site commissioning.
Buyer questions
Answers to common RFQ and acceptance questions
When is Filling Line Utility Load Guide useful?
Factories preparing infrastructure before equipment arrival. A list of motor kilowatts is not a complete utility schedule and may omit air, process water or heat rejection.
What details should be supplied before requesting a quotation?
Prepare the following project-specific information: site voltage and frequency, available transformer capacity, air pressure and flow, water and drainage, steam cooling or ventilation. Drawings, photos and representative samples help the engineering review move from a budget assumption to a defined scope.
How should the proposed solution be checked before acceptance?
Use an agreed review or test plan to issue a consolidated utility table, mark connection points, compare peak and normal loads, test utilities before commissioning. Record the conditions, measurements and open actions so the result can be compared with the approved specification.
One-Stop Beverage Equipment Solutions
Send the liquid, bottle, output and destination
Allot Technology (Suzhou) Co., Ltd. was founded in 2019. Our roots are in new-media and online communication; since 2025, we have combined that experience with China manufacturing sourcing to introduce practical beverage and liquid-packaging equipment to global buyers honestly and clearly.